Calibrating The Ptw 1500 Adjusting Gauge; Adjusting The Ptw 1500 Tungsten Electrode - Fronius Robacta PTW 500 Instructions De Service

Adjusting the
PTW 500 tungs-
ten electrode
(continued)
Calibrating the
PTW 1500 adjus-
ting gauge
Setting the adjusting gauge to measurement „x"
Adjusting the
PTW 1500 tungs-
ten electrode
Loosen the torch cap - caution, the tungsten
electrode may fall out of the plasma torch if the
torch is in a particular position.
5
1
6
3
NOTE! The standard setting for
measurement „x" on the adjusting
gauge depends on the diameter
of the plasma nozzle. Refer to the
following table when adjusting the
standard setting for measurement
„x":
∅ ∅ ∅ ∅ ∅ Plasma
nozzle
1.0 mm
1.5 mm
2.0 mm
2.5 mm
3.0 mm
Place adjusting gauge onto plasma nozzle ...
10
1
2
„x" Adjusting
gauge
- -
∅ 1.5 - 2 mm
1.5 mm
∅ 1.5 - 2 mm
2.0 mm
∅ 2.5 - 3 mm
2.5 mm
2.5 mm ∅ 2.5 - 3 mm