6.7 Help
Run the help system of this software.
6.8 Exit
Exit and shut down this software.
Chapter 7
CLEANING DISINFECTING
AND MAINTENANCE
7.1 Cleaning
Keep the outside surface of the device clean and free of dust and dirt,
and clean exterior surface of the device(including LCD screen) with a dry, soft
cloth. If necessary, clean the chassis with a soft cloth soaked in a solution
of soap or water, and wipe dry with a clean cloth immediately.
Attention:
Before cleaning, switch off the power.
Don't use the strong solvent, such as acetone.
Never use an abrasive such as steel wool or metal polish.
The temperature of the water which is used for cleaning the device should be
below 60°C.
Do not allow any liquid to enter the product,and do not immerse any parts
of the device into any liquids.
Avoid pouring liquids on the device while cleaning.
Don't remain any cleaning solution on the surface of the device.
7.2 Disinfecting
After cleaning the device, wipe the surface of device with ethanol, self-air dry
(or clean with a clean, dry cloth).
Attention:
Never try to sterilize the equipment by low pressure steam or high
temperature sterilizing process.
Do not use E-beam or gamma radiation sterilization or other methods.
ENGLISH
82