Gima CMS-VESD Notice D'utilisation page 72

If the Device has not connected to the computer, the system will pop up the
dialog box as follows:
If the Device has been connected the computer, the system will enter the state
of wait for uploading, as shown in Fig. 6-12, if the version of the Device
is Without Blueth, the system will directly enter the state of wait for uploading,
as shown in Fig. 6-12:
Fig. 6-12
At this point you should operate the stethoscope to upload the files of case
history as soon as possible.
 If you do not have time to upload files during the process of waiting,
the system will pop up the dialog box as shown in Fig. 6-13 in the end.
Fig. 6-13
 If you had done the uploading operation during the process of waiting, but it
still pop-up dialog box shown as Fig. 6-13, then you should check whether
the connect line between equipment and the computer is correct, after
checked, you can try to reconnect the device, and then operate it according
to the above introduction.
 If the version of the Device is Without Blueth and the connection is
successful, system will directly enter the uploading interface, as shown
in Fig. 6-14 (ECG cases) and Fig. 6-15 (SpO
 If the version of the Device is With Blueth, the system will pop up the dialog
box as follows. Finish rececing data, system will directly enter the uploading
interface, as shown in Fig. 6-16 (ECG cases) and Fig. 6-17 (SpO
ENGLISH
cases).
2
72
cases)
2