Initiating A Scan For New Microinverters - Enphase Energy Envoy Manuel D'installation

(n)devices
have failed
Updating...
Select to exit
3. Press the menu button to exit this menu.

Initiating a Scan for New Microinverters

If you add additional microinverters to an existing system or replace a
microinverter, you will need to run a scan to detect the new devices. To initiate a
scan after you add new microinverters to an existing Enphase system:
1. Press and hold the Envoy Menu button; after two seconds you will enter the
Envoy menu.
2. Continue holding the Menu button; when the LCD screen displays "Enable
New Device Scan", release the Menu button.
The LCD screen then reads:
The Envoy begins a 30-minute scan (if a longer scan is not already in
progress) to identify all of the microinverters deployed at the site.
3. Use your previously issued username and password to check for the new
microinverter in Enlighten. If you do not have a link to Enlighten, go to
www.enphase.com
(if not already done) and view data on a per-microinverter basis (and,
hence, a per-PV module basis).
4. To disable or cancel a scan, press and hold the Envoy Menu button for two
seconds to view the Envoy menu. When the LCD screen displays: "Disable
New Device Scan", release the Menu button.
23
Enable
New Device Scan
Device scan active
for 00d:00h:30m
and click Enlighten Login. From here you can register
Disable
New Device Scan
Copyright  2011 Enphase Energy
Number of devices that failed to be
set with a grid profile.
Updating grid configuration data.
141-00014 Rev 02
e
n
g
l
i
s
h