Wall Mount The Envoy (Optional) - Enphase Energy Envoy Manuel D'installation

9. Wall Mount the Envoy (Optional)

NOTE: Before mounting the Envoy, it is best to perform a Communication
Check as described on page 20 to optimize the location of your Envoy.
After you have positioned your Envoy for optimal communications and it is has
begun to detect devices, you may want to mount the Envoy on a wall. To do this:
a . Select a cool, dry, indoor location for the Envoy.
b . Use two drywall screws or wall anchors (not included in kit) to affix the Envoy
to the wall, mounted at the dimensions shown. You will need two #8 (4,166
mm or 0,164 inch diameter); maximum screw head diameter is 8.9mm (0,35
inches). A #8 screw is recommended.
c . Slide the Envoy onto the mounting screws, aligning the Envoy screw holes
with the screws installed in step b.
11 Copyright  2011 Enphase Energy
e
n
g
l
i
s
h
141-00014 Rev 02