Performing A Communication Check - Enphase Energy Envoy Manuel D'installation

To select a menu item, release the Menu button when the desired menu item
appears. The menu continues to cycle as long as you are pressing the Menu button.
The Exit Menu option returns to the default display.
See the following sections for detailed procedures.

Performing a Communication Check

If, when you are installing the Envoy, you are unsure of where it should be located
for maximum performance, you may want to install the Envoy in various locations
and check signal strength. Normally, a communication check starts automatically
after an Envoy restart. Alternatively, you can initiate a communication check with
the Envoy Menu button or through the administration page when connected to the
Envoy local interface with a computer, or via Enlighten (See Using Enlighten to
Check Envoy Status on page 26).
NOTE: If a Priority Scan is active, the Communication Check will not occur
until the Priority Scan has expired. If you need to run a Communication
Check, you can unplug the Envoy and then plug it in again or wait until
priority scanning has ended during which time the signal bars will return.
NOTE: Device scans and communication checks can only be successfully
performed during daylight hours when the microinverters are powered by the
PV modules.
To use the Envoy Menu button to initiate a communication check:
1. Press and hold the Menu button on the right side of the Envoy to bring up
the Envoy menu on the LCD screen.
20
View Grid
Configuration
Get New IP Address
Enable Connection
To Enphase
Disable Connection
To Enphase
Select New Locale
Copyright  2011 Enphase Energy 141-00014 Rev 02