Install The Envoy; Add Serial Number Label To Map; Register The Envoy - Enphase Energy Envoy Manuel D'installation

Install the Envoy

To install the Envoy, perform the steps below while referring to the diagram shown.

1. Add Serial Number Label to Map

a . Remove the Envoy removable serial number label as shown in the diagram.
b . Attach the serial number label to the microinverter installation map. (This
applies to new installations only and is not necessary for an Envoy
replacement.)

2. Register the Envoy

Register the Envoy at the beginning of the PV installation.
a . Visit http://enphase.com/products/enlighten/
b . If not already done, register the site owner information in the online form.
c . Register the Envoy serial number in the space provided in the online form.
8 Copyright  2011 Enphase Energy 141-00014 Rev 02