Envoy Operation; Initial Screen Displays - Enphase Energy Envoy Manuel D'installation

Envoy Operation

Initial Screen Displays

It takes less than five minutes for the Envoy to be ready to work after applying
power. This five-minute period is known as a boot sequence. You will know the
Envoy has completed booting and has started normal operation when it displays
both an IP address and the "+Web" status indication in the LCD screen. This
information is displayed on the "home screen". The boot sequence is shown:
Normal
boot
sequence
The Envoy normally displays "-Web" for 2 to 3 minutes after the first start up. It
then sends the first report to Enlighten. If Enlighten responds, the Envoy displays
+Web. Power production will show as 0W and 0kWh until the microinverters are
discovered, the grid profile is applied, and power production begins.
16

INITIALIZING
[e] Enphase Energy
Booting [≡≡≡≡≡≡]
{LANGUAGE SELECTION}
Starting
2011/06/06 16:21:20
x.x.x.x
2407W 783kWh
Comm Check
Searching...
192.168.2.140
2407W 783kWh
[≡≡≡ ] mm:ss
Level Devices: 25
Copyright  2011 Enphase Energy
Language selection
options are:
English, Français,
Deutsch, and
Italiano. These
options continue to
display until you
R3.0.0
make a selection.
-Web
25
-Web
+Web
25
+Web
Normal
boot
sequence
141-00014 Rev 02