Operation; Presentation - socomec ATyS C40 Notice D'utilisation

ATyS
Controller

OPERATION

ATyS C40

Presentation

The product allows:
• sources control,
• automatic transfer control in AUT mode,
• parameters configuration,
FAULT led
Led is on when product is faulty.
Disconnect power supplies to reset
POWER led
Green led is on when product is
powered
Sources state
- Led is on: source = OK
- Led is off: source is not available
- Led is blinking: order to start is running
Switch state
2 green leds:
- switch I state
- switch II state
42
• voltage and frequency metering,
• system state display,
• alarm or fault indication,
LCD
7 digits + 14 pointers
Keypad
Escape
LCD & leds test
Operations
Operational modes
- Active source: to force the next active source
- Partial counter reset
- Genset remote start (test of load)
Presentation
Operational modes
Programming
Operation
Visualisation
Automatic sequences
Navigation
Validation
SOCOMEC - Réf. : 532 929 B