Diagnostics And Troubleshooting - Tecno-gaz B-MAX Manuel De L'utilisateur

EXTRAORDINARY MAINTENANCE AND REPAIRS
B‐MAX does not require extraordinary or periodic maintenance; it does not have
mechanical parts or gaskets subject to wear.
Any other type of maintenance work that is not explicitly envisaged is to be carried
out only by TECNO‐GAZ or by authorized personnel.
Unauthorized maintenance work is considered tampering and will automatically
terminate the guarantee and the non‐liability of TECNO‐GAZ for damaging events
consequent to the said maintenance work.
DIAGNOSTICS AND TROUBLESHOOTING
The CONTROL button
(3) is not working
properly.
The display does not
come on.
The lamp switches
itself off during use.
The intensity of
radiation is reduced.
If the button is pressed
too forcefully, the lamp
could switch itself off
and not work properly.
The battery may be flat
or there may be
problems with the
battery connection.
The lamp is not charged, or the start button (4) has been
pressed accidentally for more than 2 seconds.
The optical fibre has
become opaque, or has
deteriorated and black
streaks can be seen. The
battery is very flat.
To solve the problem, switch the
lamp off
and then on again to reset it. If the
fault
situation continues, recharge the
battery.
Press the buttons gently.
Recharge the battery or take it out,
clean
the contacts and put it back in its
compartment.
Replace the optical fibre. Recharge
the battery.
19
ENGLISH