Tecno-gaz B-MAX Manuel De L'utilisateur page 34

The lamp emits an intense blue light radiation that interacts with the catalyst present in
the polymer and hardens it. The intensity of the emitted light and the treatment time
can be varied to modify the speed and degree of polymerization so allowing
solidification shrinkage to be limited and the final hardness of the compound to be
varied.
TECNO GAZ DISPLAY ‐ CYCLE DISPLAY DRAWING.
To switch on the lamp, hold the on/off button (4) down for 2 seconds.
The lamp will emit an acoustic signal, the display will light up, the words TECNO GAZ
will appear and the lamp will put itself in the mode relevant to the last cycle carried
out.
In the off position, the display clearly indicates all the data relevant to the chosen cycle:
a‐ chosen program type (displayed for 1 second)
b‐ chosen treatment time
c‐ battery charge status
d‐ abbreviated and fixed indication of the chosen cycle
In the on/operating position, the display clearly shows:
a‐ type of program used
b‐ remaining treatment time with countdown
c‐ battery charge status
d‐ progressive graph of the cycle
LAMP CONTROLS
1 TURBO program selection button
2 Treatment time selection button
3 Program selection button
4 Treatment cycle on/off button
Fig. 8
SWITCHING ON THE LAMP
INFORMATION ON THE DISPLAY
DRAWINGS
13
ENGLISH