Promac 930E Notice Originale page 33

DISPOSAL
General provisions
The final dismantling and scrapping of the machine must take into account the nature and composition
of the materials to be disposed of. This means in detail:
- Ferrous materials and cast iron, which however always consists only of metal, which is a secondary
raw material, must be handed over to the ironworks authorised to carry out the melting, subject to the
remuneration of the components contained.
- The electrical components, including power cables and electronic material that is considered to be
assimilable to urban waste, can be handed over directly to the waste collection service.
- For used mineral, synthetic or mixed oils, water-soluble oils and greases, which are special waste, you
must contact the Consortium for Used Oils for storage, transport and subsequent disposal.
Note: As the regulations and laws governing disposal are constantly changing and are therefore subject to change and new
regulations, the user is advised to inform himself about the respective regulations for dismantling machine tools, which may
deviate from the above-mentioned standards. In any case, the information given is to be regarded as general and purely
indicative.
33