Workplace - Promac 930E Notice Originale

Work safety-related instructions
Transport of the machine
The model 930E weighs up to 216kg.
1.
Use suitable means to transport the machine.
2.
The centre of gravity of the machine is very high, take care: there is a danger of tipping over during transport!
3.

Workplace

The lighting and ventilation of the workroom must be adequate.
1.
The lighting for safe working needs to be 300 LUX.
2.
Noise level
According to point 1.7.4f of the Machinery Directive 2006/42/EC
4 measurements of the machine were made during idle run mode:
- The microphone was mounted on the operator's head at a medium height.
- The continuous noise level was below 70 dB (A).
- The instantaneous C-weighted sound pressure measured was always below 130 dB.
NOTE: When the machine is running, the noise level will vary depending on the materials being machined. Therefore, the user will
have to assess the intensity and provide, if necessary, the personnel with ear protections according to the terms of the D.L.
vo277/1991.
Electrical mains connection
The machine model 930E is supplied with a power cable without plug, 400V, 50Hz. The connections as well as changes to
1.
the mains connection must be carried out by a specialist in accordance with standard EN60204-1, section 5.3.
The fuse must be at least 10 A.
2.
The exact electrical data can be found on the machine's type plate and the electrical diagram, enclosed with these
3.
instructions.
ATTENTION: For all service or change-over work and repairs, the machine must be disconnected from the electrical mains
4.
(pull out the plug).
The yellow/green earth cable is important for electrical safety. It is therefore important to make sure that the installation is correct.
Mandatory: always wear
safety glasses!
22