Promac 930E Notice Originale page 21

10. Do not use attachments for work for which they are not designed.
11. Wear proper work clothing; avoid loose clothing, gloves, scarves, rings, necklaces, hand chains or other
jewellery. These could get caught in moving machine parts. Wear shoes with non-slip soles. Wear a
headgear that completely covers long hair.
12. Always wear protective goggles. Proceed in accordance with the accident prevention regulations. Also
wear a dust mask when working with dust.
13. Clamp workpieces. Always use a vice or clamping device to hold the workpiece. This is safer than using
your hand and both hands are free to operate the machine.
14. Pay attention to stability. Always keep your feet and physical balance in such a way as to ensure that you
stand securely.
15. Always keep the machine in perfect condition. To do this, keep the cutting surfaces sharp and clean for
optimum performance. Follow the operating instructions for cleaning, lubricating and changing accessory
equipment.
16. Always disconnect the machine from the mains before carrying out maintenance work or changing
machine parts such as drills, etc.
17. Only use the recommended accessories. Follow the instructions in the User Manual. The use of
unsuitable accessories may result in accidents.
18. Avoid unintentional start-up. Before connection to the mains, always check that the operating switch is in
the "0" (off) position.
19. Never get on the machine. Serious injury is possible if the machine tips over or comes into contact with
the cutting tool.
20. Check defective machine parts. Damaged guards or other parts should be properly repaired or replaced
before further use.
21. Never leave the machine unattended during operation. Always switch off the mains supply. Do not leave
the machine until it has come to a complete standstill.
22. Never operate the machine under the influence of alcohol, medication or drugs.
23. Ensure that the machine is disconnected from the mains supply before working on the electrical system,
on the motor etc.
21