Components Of The Omnicam; Removing The Mirror Sleeve; Refitting The Mirror Sleeve - Dentsply Sirona CEREC AF Notice D'utilisation

8 Maintenance
66
Operating Instructions CEREC AF / AF Connect / AI / AI Connect / AI for Rear
8.1.3.2

Components of the Omnicam

A Press detent to release
B Mirror sleeve
8.1.3.3

Removing the mirror sleeve

If required to remove the mirror sleeve do the following:
1. Press the mirror sleeve against the camera body.
2. Press detent A.
NOTE
There is a risk of damaging the camera windows or the coated
sapphire glass, if the mirror sleeve is not pushed straight toward the
front.
➢ Push the mirror sleeve straight toward the front – do not tilt.
3. Pull off the mirror sleeve.
8.1.3.4

Refitting the mirror sleeve

NOTE
There is a risk of damaging the camera windows or the coated
sapphire glass, if the mirror sleeve is not pushed straight toward the
camera body.
➢ The mirror sleeve must not come into contact with the camera
windows.
➢ Push the mirror sleeve straight toward the camera body – do not
tilt.
➢ Carefully refit the mirror sleeve until it locks in place.
Dentsply Sirona
C Sapphire glass (coated)
D Camera windows
66 37 487 D3652
D3652.201.01.19.02 10.2018