Dentsply Sirona CEREC AF Notice D'utilisation page 44

6 Installation and startup
42
Operating Instructions CEREC AF / AF Connect / AI / AI Connect / AI for Rear
Extension cable option
The following applies for the optional integration of a 50 c m extension
cable:
1. Carefully release the connection between the CEREC Omnicam
cable and the camera cradle cable.
2. Carefully insert the connector of the CEREC Omnicam cable into
the coupling on the extension cable, watching out for the guide
nose.
3. Insert the extension cable connector (which is now connected to the
CEREC Omnicam cable on the camera side) into the supply cable
coupling, watching out for the guide nose, so that the connection
with the coupling box cable is re-established.
Notes on network installation
CEREC AF/AI/AI for Rear and the milling machine must be connected
via LAN cable.
Your network operator must ensure that LAN cables and provided and
installed so that you can connect the PC to the milling machine.
The network card is installed.
Dentsply Sirona
66 37 487 D3652
D3652.201.01.19.02 10.2018