Completing Measurements - Dentsply Sirona CEREC AF Notice D'utilisation

Dentsply Sirona
Operating Instructions CEREC AF / AF Connect / AI / AI Connect / AI for Rear
66 37 487 D3652
D3652.201.01.19.02 10.2018
● When performing this activity, be careful not to accidentally cut out
any areas that e.g. are located behind the model or are otherwise
cut away from the line.
● This cut must be completed during the ACQUISITION phase using
the cutter.
7.4.7

Completing measurements

ü The exposures are complete.
1. Click on the "Next" button.
Ä The virtual model is calculated and displayed in color.
Ä Gray sections highlight data material that is missing from the
calculated model.
2. If missing data emerges in the preparation area, carry out further
scans.
3. Change back to the "ACQUISITION" phase. Perform additional
scans to complete the model structure.
NOTE
Snapping in the lock
When putting the camera back, ensure that the cradle lock is
engaged (see "Controls and functional elements [→ 35]" Point E).
7 Operation
61