Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WallPerfect W 665
•
Connect the front part with the rear part of the gun. (Fig. 5)
•
Mount the air hose (Fig. 4, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
•
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
•
Sling on the carrying strap with the unit.
•
Press the ON/OFF switch at the device.
Three different spray jet settings can be chosen on the spray gun, depending on the
application and target object.
Selecting the Spray Setting
Fig. 6 A = horizontal flat jet
Fig. 6 B = vertical flat jet
Fig. 6 C = circular jet
Adjusting the desired Spray Setting (Fig. 7)
With the union nut (1) slightly unscrewed, turn the air cap (2) to the desired spray-setting
position (arrow). Then tighten the union nut.
WARNING!
Adjusting the Material Volume (Fig. 8)
Set the material volume by turning the regulator on the trigger guard of the spray gun
-
turn to the left
+
turn to the right
i
An average flow setting provides the best result for most wall paints.
Spray Technique
•
Cover all surfaces not to be sprayed.
•
It is advisable to test the spray gun on cardboard or a similar surface to find the
correct setting.
Important: Start at the edge of the area to be sprayed. Start the spray movement
first of all, and then press the trigger. Avoid interruptions within the area
to be sprayed.
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation. Select a distance of 20-30 cm (gun length is approx. 25
cm), depending on the desired spray jet width.
Fig. 9 a:
CORRECT Even distance to the object.
Fig. 9 b:
INCORRECT An uneven distance will result in uneven paint application.
for horizontal surfaces
for vertical surfaces
for corners, edges and hard-to-reach
surfaces
Danger of injury!
Never pull the trigger guard while adjusting the air cap.
lower material volume
higher material volume
GB
17
Publicité
Table des Matières
