Interruption Of Work - WAGNER WallPerfect W 665 Mode D'emploi

GB
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
•
An even movement of the spray gun results in an even surface quality.
•
If nozzle and air cap are soiled, clean both parts with water and solvent.
i
"Cross spray" when using paint with a poor covering capacity or if the
surface is highly absorbent (Fig. 13).
i
Interior wall paint in strong colour shades should be applied at least twice
(allow first paint coat to dry first). This will ensure good coverage.

Interruption of Work

•
Turn the machine off.
•
During longer breaks, vent the container by briefly opening and then closing it again.
•
Clean nozzle openings after an interruption in operation.
Taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem­free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
1) Turn the machine off. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2) Divide the spray gun. Press the hook (Fig. 5 "click") slightly downwards. Turn the gun
front part and gun rear part against each other.
3) Screw of the container and empty it. Pull out the suction tube with container seal.
4) Preclean the container and feed tube with a brush. Clean the ventilating bore (Fig. 12, C).
i
We recommend the use of a common household washing-up brush to
clean the container.
5) Pour solvent or water into the container. Screw the container back on.
Use only solvents with a flashpoint over 21 °C.
6) Assemble the gun again (Fig. 5).
7) Turn on the machine and spray the water or solvent into a container or a cloth.
8) Repeat the above procedure until the water or solvent emerging from the nozzle is
clear.
9) Turn off the machine and divide the spray gun.
10) Screw of the container and empty it. Pull out the suction tub with container seal.
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray gun with
metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
11) Pull the ventilating hose (Fig.12 A, 14) at the top from the gun body. Screw off the valve
cover (15). Remove the diaphragm (16). Clean all the parts carefully.
12) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and water or solvent (Fig. 12, 5).
13) Clean the outside of the spray gun and container with a cloth soaked in solvent or
water.
18
WallPerfect W 665