Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
Problem
Paint in the
ventilating hose
Poor covering
capacity on the wall
Warning
If the supply cord of this appliance is
damaged, it must only be replaced
by a repair shop appointed by the
manufacturer, because special purpose
tools are required.
Warning: Do not connect the blue
or brown wire to the earth
terminal of the plug! The
wires in this mains lead are
coloured in accordance with
the following code:
blue = neutral
As the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifiying the terminals in your plug, proceed as follows:
•
Should the moulded plug have to be replaced, never re-use the defective plug or
attempt to plug it into a different 13 A socket. This could result in an electric shock.
•
Should it be necessary to exchange the fuse in the plug only use fuses approved by
ASTA in accordance with BS 1362. 5 Amp fuses may be used.
•
To ensure that the fuse and fuse carrier are correctly mounted please observe the
provided markings or colour coding in the plug.
•
After changing the fuse, always make sure that the fuse carrier is correctly inserted.
With out the fuse carrier, it is not permissible to use the plug.
•
The correct fuses and fuse carriers are available from your local electrical supplies
stockist.
22
Cause
•
Diaphragm soiled
•
Diaphragm defective
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
brown = live
WallPerfect W 665
Remedy
Clean the diaphragm
➞
Replace the diaphragm
➞
Heat spray material
➞
maximum 40°C)
Cross spray (Fig. 13)
➞
Closer to the object
➞
(to
Publicité
Table des Matières
