Selecting The Spray Setting (Fig. 4); Adjusting The Material Volume (Fig. 6); Spray Technique - WAGNER WallPerfect W 565 Mode D'emploi

GB
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards.
(Fig. 2 B)
•
Place the container on a paper base and pour in the prepared coating substance with the
aid of the feed hopper included in the scope of supply (Fig. 1, 15). Screw the container
tightly onto the spray gun.
•
Connect the front part with the rear part of the gun (Fig. 3).
•
Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!
•
Pull the trigger. The W565 has a two-stage trigger. In the first stage the turbine is started.
If the trigger guard is pressed further, the material is transported.
•
Adjust the spray setting on the spray gun.

12. Selecting the Spray Setting (Fig. 4)

WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 different spray jet shapes can be set by turning the adjustment ring (fig. 4, 1)
Fig. 5 A = vertical flat jet
Fig. 5 B = horizontal flat jet 

13. Adjusting the Material Volume (Fig. 6)

Set the material volume by turning the regulator on the trigger guard of the spray gun.
- turn to the left
+ turn to the right 

14. Spray Technique

•
Cover all surfaces not to be sprayed.
The enclosed practice poster is ideal for familiarising yourself with
i
operation of the spray gun. After these initial spray attempts it is a
good idea to perform a spray test on cardboard or a similar surface,
in order to determine the material quantity required to achieve an
optimal spray pattern.
Important: Start at the edge of the area to be sprayed. Start the spray
movement first of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
•
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation. Select a distance of 20-30 cm, depending on the desired
spray jet width.
24
for horizontal surfaces

for vertical surfaces
lower material volume

higher material volume
W 565