Selecting The Spray Setting (Wallperfect I-Spray Spray Attachment); Selecting The Spray Setting (Perfectspray Spray Attachment); Adjusting The Material Volume (Fig. 8) - WAGNER WallPerfect Flexio 585 I-Spray Traduction Du Mode D'emploi Original

GB
11. Selecting the Spray Setting
(WallPerfect i-Spray spray attachment)
WArninG! Danger of injury! never pull the trigger guard while adjusting
the air cap.
2 different spray jet shapes can be set by turning the adjustment ring (fig. 4, 1)
fig. 5 A = vertical flat jet
fig. 5 B = horizontal flat jet 
12. Selecting the Spray Setting
(PerfectSpray spray attachment)
WArninG! Danger of injury! never pull the trigger guard while adjusting
the air cap.
With the union nut (fig. 6, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
fig. 7 A = vertical flat jet
fig. 7 B = horizontal flat jet 
fig. 7 C = circular jet

13. Adjusting the Material Volume (fig. 8)

Set the material volume by turning the regulator on the trigger guard of the spray gun.
lower material volume
higher material volume
28
for horizontal surfaces

for vertical surfaces
for horizontal surfaces

for vertical surfaces
for corners, edges and hard-to-reach surfaces

turn anti-clockwise (-)

turn clockwise (+)

Flexio 585 I-Spray