Selecting The Spray Setting (Wall Extra I-Spray Spray Attachment); Adjusting The Material Volume (Standard Spray Attachment) (Fig. 10); Adjusting The Material Volume (Wall Extra I-Spray Spray Attachment) - WAGNER W 690 FLEXIO Traduction Du Mode D'emploi Original

GB
12. Selecting the Spray Setting
(Wall Extra I-Spray spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 different spray jet shapes can be set by turning the air cap (fig. 8, 1)
Tighten the union nut (Fig. 8, 2) fully so that no paint is able to penetrate
the device. Check regularly whether the union nut has worked loose during
operation.
Fig. 9 A = vertical flat jet
Fig. 9 B = horizontal flat jet 
Use the red adjustment lever to also switch between a wide
( ) and a narrow (
13. Adjusting the Material Volume
(Standard spray attachment) (Fig. 10)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
- turn to the left
+ turn to the right 
14. Adjusting the Material Volume
(Wall Extra I-Spray spray attachment)
The volume of material can be set by turning the material volume control (Fig. 11, 1) in
steps from 1 (minimum) to 12 (maximum).
28
for horizontal surfaces

for vertical surfaces
) spray jet.
lower material volume

higher material volume
W 690 Flexio