Selecting The Spray Setting (Wall Extra I-Spray Spray Attachment); Adjusting The Material Volume (Fig. 7, Item 3); Setting The Amount Of Air (Fig. 7, Item 1) - WAGNER W 890 FLEXIO Traduction Du Mode D'emploi Original

GB
12. Selecting the Spray Setting
(Wall Extra I-Spray spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 different spray jet shapes can be set by turning the adjustment ring (fig. 10, 1)
Fig. 11 A = vertical flat jet
Fig. 11 B = horizontal flat jet
Use the red adjustment lever to also switch between a wide ( )
and a narrow ( ) spray jet.

13. Adjusting the Material Volume (Fig. 7, item 3)

Set the material volume by turning the regulator on the trigger guard of the spray gun.
- turn to the left
+ turn to the right 

14. Setting the Amount of Air (Fig. 7, item 1)

Depending on the viscosity of the material to be sprayed and the finish of the object to be
coated, it may be advisable to vary the amount of air. Very low viscosity materials, such as
watery glazes do not have to be atomised with the maximum amount of air. In this case it
is advisable to reduce the amount of air and thus minimize the spray vapour.
This also applies for the use of the Detail and Corner&Reach spray attachment (accessory).
- turn to the left
+ turn to the right
30


lower material volume

higher material volume
 lower amount of air
 higher amount of air
for horizontal surfaces
for vertical surfaces
W 890 Flexio