WAGNER WallPerfect W 665 Mode D'emploi page 25

WallPerfect W 665
14) Assemble the parts again (see "Assembly").
Assembly
The unit may only be operated with an integer diaphragm (Fig. 12 A, 16). Place the
diaphragm with the pin facing upwards on the bottom section of the valve. Also see
the marking on the gun body. Place on the valve cover and screw it closed. Place the
ventilating hose on the valve cover and on the nipple at the gun body.
Slide the nozzle seal (Item 4) with the groove (slot) facing forwards into the nozzle (Fig. 12 B).
Put the nozzle onto the gun body and find the correct position by turning it. Put the air
cap onto the nozzle and tighten it using the union nut.
Place the container seal from below on the suction tube and slide it over the collar, while
turning the container seal slightly. Insert the suction tube with container seal in the gun
body.
Maintenance
Change the air filter if it is soiled. Use a screwdriver to lever the cover fastening from the
unit (Fig. 11, arrow). The smooth side of the air filter (Fig. 11, 1) must be placed towards
the machine. Replace the cover on the unit until it latches.
WARNING! Never operate the machine without the air filter; dirt could be sucked in
and interfere with the function of the machine.
In order to mount the gun more easily apply lubricating grease (enclosed) liberally
to the O­ring at the gun front part (Fig. 12, 18).
Pos. Name
1 Union nut
2 Air cap
3 Nozzle
4 Nozzle seal
5 WallPerfect spray attachment incl. 1800 ml. conainer
6 Handle
7 Air hose
8 Carrying belt
9 Cover
10 Air filter
11 Container with cover 1800 ml (only for WallPerfect
spray attachment)
12 Suction tube
13 Container seal
14 Ventilating hose
15 Valve cover
16 Diaphragm
17 Feed hopper (3x)
Lubricating grease
Spare Parts List (Fig. 12)
GB
Order No.
0417 471
0417 470
0417 468
0417 465
2301 734
2303 300
2303 410
0414 204
0414 302
0414 700
2304 025
0417 473
0417 474
2304 027
2304 028
9892 550
19