Safety Features; Cleaning And Maintenance - EUROM Mon Soleil 300 Ceiling Wifi Manuel D'utilisation

Safety features

In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially) covering
the heater, or installing the heater too close to a wall or something similar. In case
of overheating, switch off the heater and unplug. Give the heater time to cool down,
remove the source of the overheating and use as normal. If the problem persists or
if you have not been able to trace the source of the overheating, turn the heater off
immediately and unplug. Contact a servicing point to have the heater repaired.

Cleaning and maintenance

Keep the heater clean. Switch off the heater, remove the plug from the socket and
allow the heater to cool down before cleaning or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do

not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions; This can cause irreparable scratches and damage!. Never
use cloths that are too wet, dry the appliance properly and ensure that the
entire unit is dry before taking it back into use.
You can keep the back of the heater free of dust with a feather duster. For

thorough cleaning of the back, you can take the heater from the ceiling.
If you want to store the heater at the end of the season, remove it from the

ceiling, unscrew the suspension frame (if applicable) and store the entire unit
(in the original packaging) upright in a cool, dry and frost-free place.
Removal
In the EU this symbol indicates that this product may not be
disposed of as ordinary household waste. Old equipment
contains valuable materials, suitable for recycling. These
materials should be made suitable for reuse in order to prevent
any adverse effects to health and the environment caused by
unregulated waste collection. Therefore, please make sure that
you bring old equipment to a designated collection point.
Alternatively, contact the original supplier, who can make sure
that as many of the components as possible can be recycled.
47