Safety Features; Cleaning And Maintenance - EUROM Safe-t-Heater 2000 Tower Manuel D'utilisation

 The display shows all set functions.
Attention! The heater remains hot for some time after use!
Remote control
 The remote control is equipped with a battery. Remove
before first use plastic security plate.
 The buttons on the remote control work in the same
manner as those on the control panel.
 Ensure that there are no obstacles between the remote
control and the receiver on the heater!

Safety features

The heater is fitted with a tipping safeguard which
automatically shuts off the appliance if it inadvertently falls
over. When the heater is returned to its upright position, it
will resume functioning as normal but, before reusing, switch
off, unplug and check for damage. Do not use the heater if it is damaged or
malfunctioning, but have it inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the overheating safeguard
switches the heater off, you must then switch off by means of the operation panel
and main switch. Unplug and allow the heater to cool down. Remove and/or amend
the cause of overheating and use again, as normal. If you cannot find a cause and
overheating recurs, stop using the heater, and take it in for inspection/repair.

Cleaning and maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do

not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!
Open the back, remove the filter (illustration with Description) and beat it clean

or rinse it carefully. Allow it to dry very thoroughly before putting it back!
Using a vacuum cleaner, carefully remove any dust and dirt from the grills and

ensure that the air intake and outlet openings are clean. Be careful not to touch
or damage any internal parts during cleaning!
The heater contains no other parts which need maintenance.

Place the filter in the correct position and close the back again.

31