Safety Features; Cleaning And Maintenance - EUROM Safe-t-Shine 900 Manuel D'utilisation

 In order to switch both lamps off again, turn the relevant button back to OFF.
The light will go out. The heater is now off. Then remove the plug from the
socket. Never leave the heater plugged in when it is not in use!
 Please note: When you use the heater for the first time, a little smoke and an
odour may be produced. This is normal and harmless, and should cease after a
few minutes. If the heater does not stop smoking, switch the heater off, remove
the plug from the socket and contact your supplier.
 The heater, and particularly the radiation grid, become extremely hot during use
and will also remain warm for some time after the heater has been switched off.
 If you wish to relocate the heater, first switch it off, remove the plug from the
socket and allow it to cool down before moving it. To relocate the heater, use
the handle at the top.

Safety features

A push button is located beneath the heater: this is the safety tip-over cut-out
switch. Knocking over the heater will cause this button to protrude and the heater
will turn off automatically. This means the heater will not work when hanging.
However, this does not rule out all risks: even after the heater has been switched
off, it and particularly the radiation grid, will remain very hot for some time and if it
is left lying, for example, on a wooden floor or carpet, it can cause
fire/melting/scorching damage and result in a fire. Therefore remain cautious at all
times!
When the heater is returned to its upright position, it will resume functioning as
normal but, before reusing, switch off, unplug and check for damage. Do not use
the heater if it is damaged or malfunctioning, but have it inspected/repaired!

Cleaning and Maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do

not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!
Using a vacuum cleaner, carefully remove any dust and dirt from the grills. Be

careful not to touch or damage any internal parts during cleaning!
The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if

necessary. Store it upright in a cool, dry and dust-free place.
31