Safety Features; Cleaning And Maintenance - EUROM C.U. 2000 Manuel D'utilisation

flashing, press on + (or -) to set a time period: from 0 to 24 hours, with half hour
intervals. The timer works with all four MODE settings. The display will show the
temperature again a few seconds after setting the time period. To see how much
time is left, press the timer button again.
To switch the heater off, set the main switch to O (off); this will erase all settings.
Allow the appliance to cool down for 30 seconds and remove the plug from the
power socket. Always remove the plug from the socket if the heater is not working!
Attention! The heater remains hot for some time after use!

Safety features

Tipping Safeguard
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal (you have to select MODE again) but,
before reusing, switch off, unplug and check for damage. Do not use the heater if
it is damaged or malfunctioning, but have it inspected/repaired!
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the overheating safeguard
switches the heater off, you must then switch off by means of the main switch.
Unplug and allow the heater to cool down. Remove and/or amend the cause of
overheating and use again, as normal. If you cannot find a cause and overheating
recurs, stop using the heater, and take it in for inspection/repair.

Cleaning and maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do

not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!
Open the back, remove the filter (illustration with Description) and beat it clean

or rinse it carefully. Allow it to dry very thoroughly before putting it back!
Using a vacuum cleaner, carefully remove any dust and dirt from the grills and

ensure that the air intake and outlet openings are clean. Be careful not to touch
or damage any internal parts during cleaning!
31