EUROM Mon Soleil 300 Ceiling Wifi Manuel D'utilisation page 44

stops blinking and goes completely green and the blinking P on the Smart Plug
screen disappears.
 The connection process is complete.
 Press the ON/OFF button (9) on the Smart Plug; the heating panel can now be
operated using the Smart Plug.
Note: The heating panel can now only be operated with the Smart Plug. The
communication distance between the Smart Plug and the panel is a maximum of 30
m (without any obstacles).
Note: The heater will stop after some time the Smart Plug is removed.
Connect multiple panels to the same Smart Plug
Connect the first heating panel as described above. Once the first panel has been
successfully connected, follow the same procedure for the second, and other
heating panels.
Once connected, check whether all of the linked heating panels respond
simultaneously when you set the desired temperature using the Smart Plug.
The red indicator light 'heating' should go on and off on all of the linked panels at
the same time.
Operating the heating panel with the Smart Plug
Before: The main switch on the heating panel (4) must be set to ON and the green
indicator light 'connecting' (1) must be lit up. The Smart Plug must be inserted into
a suitable socket and switched on via the ON/OFF button (9).
Please note (1): Before operating the heating panel with the Smart Plug/Eurom
Smart App, check to ensure that the green light on the heating panel is on
(continuously). If the green light is blinking or not on, there is no connection
between the heating panel and the Smart Plug. You can then use the buttons on
the Smart Plug but commands will not be passed onto the heating panel.
Please note (2): If the Smart Plug temporarily loses its 230 Volt supply, the
Smart Plug and the heating panel will be switched off when the 230 Volt supply is
reconnected. This prevents the room being heated to an undesirable temperature.
1. The ambient temperature will be displayed on the Smart Plug. The word ROOM
will appear on the display to indicate that the environmental temperature is
shown. (The set temperature is the last temperature that was set or 18
degrees, the first time the device is used). If the set temperature is higher than
the ambient temperature, the heating panel will begin to heat; the heating
symbol will be shown on the Smart Plug display, and the red light will light up on
the heating panel. The Wi-Fi symbol will blink on the Smart Plug display. If the
Wi-Fi symbol blinks, it means that a connection can be made with the App
(smartdevice). (see details in the back of this instruction booklet.
44