EUROM Mon Soleil 300 Ceiling Wifi Manuel D'utilisation page 45

2. The + and – buttons (8) can be used to adjust the desired temperature (0-37
degrees). The word 'SET' will appear on the Smart Plug display to indicate that
you have set a desired temperature. After a few seconds, the desired
temperature will disappear from the display and the ambient temperature will be
shown. The word ROOM will appear on the display to indicate that the ambient
temperature is shown.
If the set temperature is higher than the ambient temperature, the heating
panel will begin to heat; the heating symbol will be shown on the Smart Plug
display, and the red light will light up on the heating panel.
Once the set temperature is reached, the heating panel automatically turns off,
and then back on again when it cools down.
The heating symbol on the Smart Plug and the red light on the heating panel go
on and off accordingly.
If no buttons on the Smart Plug are pressed for a few seconds, the display light
will automatically dim. The display light will come back on when you press any
button.
Timer
The Smart Plug contains a timer to automatically turn the heating panel off. Press
the Timer button (6) on the Smart Plug several times to set the number of hours
after which the heating panel should be automatically switched off.
ByPass mode
It is possible to use the heating panel without a Smart Plug. The panel can be
operated using the ON/OFF button (4) on the panel itself. A desired temperature
cannot, however, be set.
In order to set the heating panel in ByPass mode, proceed as follows:
Press and hold the P button (3) on the heating panel until the indicator light
-
for connecting (green) goes off and the light for heating (red) goes on.
To turn off ByPass mode; press the P button (3) on the heating panel twice and the
green light will start to blink.
Wifi and App operation
The heating panel can also be operated using an app on your smartphone. The
Smart Plug must be connected with a Wi-Fi modem. See inside the back of this
booklet for instructions on how to install the app. To operate the heating panel
using the Eurom Smart App, the Smart Plug screen will show the Wi-Fi symbol
blinking rapidly.
Scan the QR code below with the smart device, or search for 'Eurom Smart' in the
-
App store or Google Play and follow the download instructions.
45