EUROM Mon Soleil 300 Ceiling Wifi Manuel D'utilisation page 41

using the Eurom Smart App when the Smart Plug is connected with a WiFi modem.
See inside the back of this booklet for instructions on how to install the app.
Remove all packaging material and keep out of reach of children.
After removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance, but
contact your vendor for inspection or replacement.
The attachment materials supplied should be used on a sturdy ceiling. If you use
another surface, you must select the appropriate attachment materials and make
sure the panel is secured properly.
The heating panel must be hung from the ceiling. The minimum distance from the
bottom of the heating panel to the floor must be 185 cm.
The heating panel should preferably be placed near an electric connection point and
connected into this. This connection may only be created by a qualified electrician
and will not therefore be described in this booklet.
For safety reasons, this booklet assumes the use of a plug; sections about the plug
are, however, irrelevant if there is a fixed connection point. The electrical
connection must always be earthed and secured with 1 30 mA earth leakage circuit
breaker.
Attachment to the ceiling
The heating panel must be at least 20 cm from all objects, walls and so on. The
minimum distance from the ceiling is 4 cm as this allows an airflow which will prevent
the heating panel from overheating. The minimum distance from the bottom of the
heating panel to the floor must be 185 cm. Choose a sturdy, even ceiling made of
heat-proof material for hanging the heating panel.
Step 1: Use the H-bracket to mark the holes in the ceiling
Position the H-bracket such that, when the heating panel is installed, the
minimum distances above are guaranteed. Make sure that the hanging
frame is installed with the correct side to the top. (see diagram)
Check and make sure that there are no cables in the ceiling before
drilling at the marked points.
Step 2: Drill holes with an 7 mm drill bit
Step 3: Push the plugs into the holes
Step 4: Secure the screws with the O-rings in the plugs through the holes in the
H-bracket
Step 5: Mount the panel on the bracket and ensure that the panel is secured as
shown in image 5.
41