EUROM Mon Soleil 300 Ceiling Wifi Manuel D'utilisation page 46

The Eurom Smart App will be added to your smart device.
-
If a connection cannot be made and the App asks for the AP mode to be used,
-
the Smart Plug must then be switched from blinking rapidly to blinking slowly, as
follows:
Press and hold the Wi-Fi button on the Smart Plug for 3 seconds and the Wi-Fi
symbol on the Smart Plug screen will change from blinking rapidly to blinking
slowly (or vice versa).
Safety precautions
Safety and remote operation
Your Eurom heater can be easily operated using your smartphone, via the same
WLAN, via a different WLAN, or via a 3G or 4G mobile network. This makes it
possible to operate your heater remotely, without your direct supervision.
Beware that even when operating the heater remotely, all safety precautions stated
in the user manual supplied must be observed. Read and understand these safety
precautions and make sure that all safety precautions are taken also with remote
operation.
Safety and setting the timer
The Eurom Smart App has two timer functions. A so-called 'countdown timer' to
switch the heater off automatically (as with the manual operation) and a 'Smart
Timer' with which you can create a schedule yourself with days and times on which
the heater is to automatically switch itself on and off. Any timer data entered into
the Eurom Smart App will be stored in the heater. This means that, once you have
entered the timer data and the heater loses the connection with the Wi-Fi modem,
the heater will still be able to switch itself on and off on your specified times.
Storing the timer data in the heater is a safety precaution. Your set on and off
times schedule will also work without a Wi-Fi connection. So the heater will not
unexpectedly continue heating up if the Wi-Fi connection (temporarily) fails.
The Smart timer data will be stored, even if the heater is switched off or the plug
is removed from the socket. The set Smart timer data can only be checked via the
App and also only be removed via the App. Bear this in mind when entering the
data into the Smart Timer. The Smart Timer data is not visible on the heater.
Regularly check in the App whether the entered Smart Timer data are still correct.
The set data for the so-called Countdown timer with which the heater can be
switched off, will not be stored when the heater is switched off. However the heater
is switched off: with the ON/OFF button, the main switch or the plug, the
Countdown timer data will be deleted.
You can consult an elaborate Eurom Smart App user manual with the QR code
below:
or on the website: http://www.eurom.nl/nl/manuals
46