Storage; De-Installation; Machine Use - Rivacold P Mode D'emploi Et D'entretien

UK
ATTENTION:

4.4. Storage

If necessary to store the machine for a period before installation (or following de-installation), we recommend you protect it
adequately and store it in a suitable environment, with the following features:
external surfaces resistant to atmospheric agents;
protected against access to unauthorised people;
with the following environmental conditions:
good ventilation;
room temperature between -20 °C and +50 °C;
relative humidity of compressed air 30% and 80%;
possibly in dry, dust-free atmosphere.
ATTENTION:

4.4.1. De-installation

If the machine must be de-installed, proceed following the inverse order for installation reported in Paragraph 4.3 - Installation.
DANGER:
To conduct the task in question, the following Individual Protection Devices are necessary:
C h a p t e r 5
C h a p t e r 5
M a c h i n e u s e
M a c h i n e u s e

5.1. Machine use

DANGER:
To use the machine, the following Individual Protection Devices are necessary:
5.1.1. Operation
Before starting the machine, it is necessary to ensure:
the locking screws are tight;
the electrical connections were correctly installed;
the coldroom door is closed to ensure the micro-door contact is closed.
5.1.2. Switch on/off
To switch on (off) the machine, it is necessary to press the "ON/OFF" key for 5 seconds placed on the control panel.
ATTENTION:
do not connect the COLDROOM LIGHT and DOOR TOLERANCE cables to the 230 Volt line. The
plates attached to each cable indicate the connection to perform. The maximum power of the lighting
unit which can be connected to the coldroom light cable (supplied) is 100W for incandescent lights
and 66W for neon lights (230V-50Hz power). The maximum power of the tolerance which can be
connected to the door tolerance cable (supplied on all the LBP models) is 300W (230V-50Hz power).
do not remove any packaging possibly present for certain components of the machine and take
adequate precautions to protect the exposed parts.
the manufacturer declines all responsibility for any damage to property and/or persons deriving from
improper interventions conducted by unqualified, untrained or unauthorised staff.
for the machine, only operators correctly training and informed on the risks present can intervene on
the machine and only having fully read this use and maintenance handbook. the manufacturer
declines all responsibility for any damage to property and/or persons deriving from improper
interventions conducted by unqualified, untrained or unauthorised staff.
when the machine is powered, the control panel display shows the writing OFF alternated with the
temperature of the coldroom.
P-SF-SV Pag. 50 Rev 00 02/11