Work Area And Position Of The Operator; Noise And Vibration Indications - Rivacold P Mode D'emploi Et D'entretien

A
B
C
D
E
F
G

3.5 Work Area and Position of the Operator

The machine functions automatically requesting the intervention of the operator corresponding to the control and command
software only to manually start and stop and for functioning programming. The operator's work area therefore exclusively
corresponds to the control panel on the machine.

3.6. Noise and Vibration Indications

3.6.1. Noise
B P - SF - SV were designed and manufactured to reduce the noise emitted during normal functioning to a minimum.
LOCKSYSTEM
LABEL
This label indicates that it is forbidden to remove the safety devices and
protections installed on the machine; it is usually accompanied by the
explicatory writing:
This label indicates that it is forbidden to perform any intervention (including
lubrication and cleaning) in proximity of moving parts; it is usually
accompanied by the explicatory writing:
MOTION
This label warns about the danger due to the presence of mobile parts in
proximity of the area in which the machine is positioned.
This label warns about the danger due to the presence of warm surfaces in
proximity of the area in which the machine is positioned.
This label warns about the danger due to the presence of elements under
voltage in proximity of the area in which the machine is positioned.
This label warks about the obligation to read the manual for the installation
Warning to the sharp parts durino condenser cleaning
DESCRIPTION
DO NOT REMOVE THE PROTECTION DEVICES
.
.
DON NOT REPAIR OR REGULATE DURING
P-SF-SV Pag. 43 REV 00 02/11
UK