Rivacold P Mode D'emploi Et D'entretien page 49

6. Remove the front panel of the machine. Insert the defrosting water drainage tube supplied, in the evaporator tank tube
making it pass through the hole made on the wall of the coldroom (Figure 6). Then, from the other end, bring the water
evaporation tank in, creating a siphon on the end part.
Having connected the tubes, check the perfect functioning of the water drain.
ATTENTION:
ATTENTION:
4.3.4. SV Series Installation Method
To proceed to installation of the machine, use the following procedure:
1. Make a hole on the walls of the coldroom of suitable dimensions as indicated in the pages of Figure 18 and Figure 19 of
Chapter 9 at the end of the handbook.
2. Position the anti-condensate slab supplied along the perimeter of the hole.
3. Lift the machine with a hoist or with another suitable vehicle.
4. Position the machine in the hole made in the wall of the coldroom and place the evaporating part in from outside.
5. Fasten the machine to the wall of the coldroom with self-threading screws using the two brackets and the screws supplied.
6. Seal the perimeter of the aluminium conveyor with silicon (suitable for use in the coldroom) to avoid infiltration of cold air
inside the coldroom.
ATTENTION:
4.3.5. Connection to electrical power mains
The electrical power supply (also in terms of voltage and frequency) supplied by the purchaser must be sufficient to correctly
power the machine. Specifically the following instructions must be followed:
The power cable must be laid out (no rolling or overlapping) in a position not exposed to possible knocks or tampering. It
must not be near liquids, water or heat sources and must not be damaged (if so, replace it using qualified staff).
Prepare a thermo-magnetic differential switch between the power line and the
corresponds to the voltage indicated on the plate (see label applied to the machine); tolerance permitted ± 10% of nominal
voltage.
ATTENTION:
It is necessary for the section of the power cable to be adequate to the power absorbed by the machine.
ATTENTION:
Fasten the micro-door supplied on the door jamb of the coldroom which automatically causes, on opening, the lights in the
coldroom to switch on and the compressor and fans to stop in the evaporator and condenser.
ATTENTION:
Fasten the light to the ceiling of the coldroom and connect the coldroom light cable following the instructions reported inside
the support.
With the LBP range units (-15°C/-25°C) a cable is supplied for connection of the door tolerance. This connection must be
conducted using a fuse dimensioned based on the tolerance of the door used.
Figure 6 – Machine assemble saddle version.
if the machine has a condensate water evaporation tank, we recommend you connect a rubber tube to
the overflow tube to enable evacuation of water in case of functioning or use anomalies.
if the machine is not equipped with a condensate water evaporation tank, lengthen the drainage tube
outside the coldroom by using a siphon.
the machine is equipped with a condensate water evaporation tank. We recommend you connect a
rubber tube to the overflow tube to enable evacuation of water in case of functioning or use
anomalies.
the thermo-magnetic differential switch must be placed in the immediate vicinity of the machine to
ensure it is well visible and reachable by the technician in case of maintenance.
It is compulsory, pursuant to law, to connect the machine to an efficient earthing system. All
responsibilities are declined for non-compliance with this directive; all responsibility is declined if the
electrical system used for connection is not implemented according to laws in force.
the micro-door cable must pass far from the cables with electrical power to avoid signal disturbances.
machine --- and ensure the voltage of the line
P-SF-SV Pag. 49 REV 00 02/11
UK