Trasportation And Movement - Rivacold P Mode D'emploi Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

UK
The power supplies and utilities necessary (responsibility of the purchaser) for machine functioning exclusively consist in the supply
of electrical energy.
Unless otherwise indicated, the purchaser is responsible for:
the preparation of transport vehicles to transport the machine to the assembly or installation location;
the preparation of equipment necessary for assembly and installation;
the preparation of the installation location;
the preparation of auxiliary vehicles and consumable materials (for example, non-flammable and non-corrosive detergents,
materials and tools necessary for cleaning and cover).
4.2. Transportation and Movement
The indications contained in this paragraph must be complied with during the transport and movement phases of the machine,
which can occur in the following situations:
machine storage;
assembly and first installation of the machine;
de-installation and dismantling of the machine;
moving and relocating the machine.
DANGER:
To conduct the task in question, the following Individual Protection Devices are necessary:
During transport or movement of the machine, it is necessary to follow the warnings below:
Check the lifting equipment is suitable for the weight and dimensions of the machine.
Do not bang the structure or guards of the machine with equipment or otherwise.
4.2.1.
Lifting
DANGER:
Lifting to move and subsequently position the machine can be performed using any adequate vehicle that guarantees its lifting in
a safe and efficient manner (for example a hoist using a harness system for the machine). See Figure 2.
To correctly perform the lifting operations, follow the warnings reported below.
Never use two lifting vehicles simultaneously.
Never stay under suspended loads.
If using steel ropes, always apply the end eye to the lifting hook.
If using steel ropes, pay attention not to create sharp bends, i.e. with a bending radius lower than that of the rope end
eyelets.
Use adequately wide ropes, to enable the angle between the ropes and the horizon to always be over 45°.
4.2.2.
Machine movement
For reduced distances, as in the case of transport to the assembly or storage locations of the machine, it is necessary to use lifting
equipment (for example, forklift and hoists) suitable for the dimensions and weight of the machine.
the manufacturer declines all responsibility for any damage to property and/or persons deriving from
improper interventions conducted by unqualified, untrained or unauthorised staff.
lifting operations must be conducted with the direct supervision of a qualified mechanical maintenance
person or a manufacturer technician.
Figure 2 – Lifting the machine.
Modell SF
Modell P
P-SF-SV Pag. 46 Rev 00 02/11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

SfSv

Table des Matières