Support; Machine Description; Control Panel - Rivacold P Mode D'emploi Et D'entretien

UK
total or partial non-compliance with the instructions reported in this handbook;
no or incorrect maintenance;
use of non-original parts or those not specified by the manufacturer.

1.6 Support

Regarding maximum use of the performance provided by the
handbook does not replace the experience of the installers, users or maintenance staff that is trained and qualified.
On the subject, the Technical Support Service of R
telephone support on the features and simplest interventions to conduct on the
sending of documentation material;
ATTENTION:
1.6.1. Intervention Support Requests
To contact the Technical Support Service contact the:
Technical Office of Rivacold s.r.l.
Via Sicilia, 7
61020 Montecchio (pu)
Italy
Telephone: (+39) 0721 919911
Fax: (+39) 0721 490015
E mail ufficiotecnico@rivacold.com
During the requests for support, specify the name, model and registration of the machine.
C h a p t e r 2
C h a p t e r 2
M a c h i n e d e
M a c h i n e d e
The machine represents a refrigerating unit composed of a condensing unit (coldroom exterior), an evaporating unit (coldroom
interior) and an electronic control panel located inside the condensing unit. The refrigerant follows the compression refrigerating
cycle system. The machine can be equipped with a hot gas defrosting system (MBP and LBP), a ventilation defrosting system (HBP)
or an electrical defrosting system, which is run with an electronic control unit. Defrosting occurs automatically with a cyclical
frequency that can be controlled by the user; it can be activated, also manually, using the relevant control.
This solution allows you to have a product that is easy to use, simple to install and offering maximum versatility. The use of state
of the art technological solutions has enabled optimisation of the dimensions of the machines, improving their installation modes,
especially on the compact coldrooms.
The PT model is a wall Blocksystem for the refrigeration of coldrooms from 2 HP to 20 HP. Specifically, the P model comes in a
plug-in (PT) or saddle version (PA).
The SF model is a ceiling Blocksystem for the refrigeration of coldrooms from 1/3 HP to 4 HP.
The SV model is a wall Blocksystem for the refrigeration of coldrooms from 3/7 HP to 1.5 HP.

2.1 Control panel

Below (Table 2) reports the description of the commands on the management software.
IVACOLD SRL
in case of doubt on the correct interpretation of instructions in this Use and Maintenance Handbook,
contact the Technical Support Service (as indicated below) to obtain the
s c r i p t i o n
s c r i p t i o n
Table 2 – commands descriptions.
and the extraordinary maintenance operations, this
MACHINE
provides:
Figure 1 Control panel
;
MACHINE
NECESSARY
P-SF-SV Pag. 38 Rev 00 02/11
clarifications.