Connecting Electricity And Ducting - Sirius SU900 Notice D'utilisation Et D'entretien

There are four holes on the inside of the
SUT900 to fix the unit into the edge of the
base of the wooden hood (refer to figure 4).
Installing a Adjustable Pro Liner with
SU901. Once the cut out has been done in-
stall the Adjustable Pro Liner and make sure
it lines up with the cut out in your cabinet.
Screw it to the 4 hole locations (refer to fi-
gure 5).
Install the front part of the liner adjusting it to
the depth of the cabinet. (refer to figure 6).
Screw it to the 3 hole locations.
Attention: be sure the cabinet has a mini-
mum thickness of 0.75" on the 4 sides.
The power pack has pressure springs (to
be adjusted) on the front and back that will
"hook" onto the top surface of the underside
of the hood when it is pushed up into the
hole that has been cut out (refer to figure 3).
Installing SU902. The power pack has
pressure springs (to be adjusted) on the
front and back that will "hook" onto the top
surface of the underside of the hood when it
is pushed up into the hole that has been cut
out (refer to figure 3).
Installing SU903. Before installing the unit,
open the central panel (see figure 7) and re-
move it (see figure 8).
The power pack has pressure springs (to
be adjusted) on the front and back that will
"hook" onto the top surface of the underside
of the hood when it is pushed up into the
hole that has been cut out (refer to figure
9). There are six holes on the inside of the
SU903 to fix the unit into the edge of the
base of the wooden cabinet (refer to figure
10).
Installing SU908
There are four holes on the inside of the SU908
to fix the unit intothe edge of the base of the wo-
oden hood (refer to figure 4).
Installing SU923 - SUE923
Before installing the appliance, remuve the
me tal grase filter. It can be removed by
pushing its special handle toward the back-
side of the cooker hood and turning the filter
downwards so to unfasten it from its slot (re-
fer to figure 11).
The power pack has pressure springs (to
be adjusted) on the front and back that will
"hook" onto the top surface of the underside
of the hood when it is pushed up into the
hole that has been cut out (refer to figure 3).
There are eight holes on the inside of the
SU923 - SUE923 to fix the unit into the edge
of the base of the wooden cabinet (refer to
figure 12).

Connecting Electricity and Ducting.

Please refer to the Electrical Supply section
on page 2 for the required location of the
electrical supply.
CAUTION: Make sure the power is turned
off at source. Make electrical connections
(refer to Figure 13). Ensure that the plastic
flaps at the exhaust outlet for the fan move
freely and have not become jammed or
stuck.
10