Installation; Applications - Sirius SU900 Notice D'utilisation Et D'entretien

Applications

The SU900 - SUT900 – SUE900 can either
be installed inside a wall cabinet (provided
the inside depth is greater than 11") or used
in a custom designed wooden hood. Whe-
re installed directly into a wall cabinet, there
are two options:
Directly into the cabinet without any form of
hood. Directly into the cabinet together with
Sch31A where the Sch31A acts as a liner
hood and is attached to either the underside
of the cabinet or into the sides of the cabi-
nets alongside.
The SU901 can either be installed inside a
wall cabinet or used in a custom designed
wooden hood. Where installed directly into
a wall cabinet, there are two options:
Directly into the cabinet or directly into the
cabinet together with the adjustable Pro li-
ners where the adjustable Pro liners act as
a cabinet protection against the heat. The
depth of the adjustable pro liners can vary
from 23.5" to 25.9" )
The SU902 and SU903 can either be instal-
led inside a wall cabinet or used in a custom
designed wooden hood.
Depending on which model is used, prepa-
re a cut-out in the underside of the wooden
hood to allow the powerpack to fit up into the
hood using the following dimensions:
SU900 - SUT900 – SUE900 20"
10" X 19"
3/8 19/32
SU900 - SUT900 – SUE900 27"
10" X 26"
3/8 11/16
SU901
32" X 16"
13/32 3/16
I N ST A L L A TI ON
9
SU902
SU903 27"
SU903 36"
SU908
SU923 - SUE923 20"
SU923 - SUE923 27"
If Sch31A or a Pro Liner are being used,
they can be held up under the cabinet and
used as a template.
If Sch31A or a Pro Liner are to be used for
under cabinet application, they should be
installed now.
Installing a SCH31A with SU900 - SUT900
– SUE900. Hold the Sch31A under the ca-
binet and Screw it to the 4 hole locations.
Make sure it lines up with the cut out in
your cabinet. The power pack has pressu-
re springs (to be adjusted) on the front and
back that will "hook" onto the top surface of
the underside of the hood when it is pushed
up into the hole that has been cut out (refer
to figure 3).
Installing SU900 - SUT900 – SUE900 wi-
thout a SCH31A. The power pack has pres-
sure springs (to be adjusted) on the front
and back that will "hook" onto the top sur-
face of the underside of the hood when it is
pushed up into the hole that has been cut
out (refer to figure 3).
10" X 26"
½
25/64
9" X 25"
15/16 9/16
9" X 33"
15/16 7/16
12" X 26"
5/8 2/2
19" X 10"
7/8 5/8
26" X 10"
31/32 5/8