Connecting Electricity And Ducting; Connecting Chimneys; Re-Circulating Requirements - Sirius SU107 Notice D'utilisation Et D'entretien

Connecting Electricity and Ducting.

Please refer to the Electrical Supply section
on page 3 for the required location of the
electrical supply.
CAUTION: Make sure the power is turned
off at source. Make electrical connections
(refer to Figure 8).
Ensure that the plastic flaps at the exhaust
outlet for the fan move freely and have not
become jammed or stuck.
Connect the appropriate length of ducting to
the fan exhaust point and join up with the
ducting to the exte-rior.
Figure 9 - 10 shows venting directly through
the wall. Venting up and through the ceiling
to the exte-rior is also possible racommen-
ded to have 18" from the top of the hood to
the first elbow.
Do not fix the ducting to the range hood
exhaust outlet with screws-use duct
tape. Use duct tape on all joints.
The air outlet of the product is oriented up-
wards: in the case that one prefers the air
outlet towards the rear side of the appliance,
it is only necessary to replace the air release
piece with the other one supplied with the
appliance Figure 11 - 12.

Connecting Chimneys

Remove the protective covering from the
decorative chimney and carefully slide the
sections together. Do not remove the tape
strips from inside the chimney as this pro-
tects the telescoping chimney-piece from
scratching. Holding the two chimney sec-
tions together carefully position them over
the ductwork and wiring. Position the upper
chimney so that it can be fixed via the holes
on the side of the 'Y" bracket on the ceiling
(refer to Figure 13).

Re-Circulating Requirements.

If the unit is to be used in the re-circulating
mode, fit the carbon filter after (fig. 14) the
installation is complete fit the deflector with
the screws supplied to the upper telescope
chimney. There are holes in the back upper
edge of (fig. 15) the decorative chimney for
this purpose. A short length of ducting is
connected between the exhaust outlet on
the fan and the deflector to direct the air
back into the kitchen through the vents at
the top of the upper decorative chimney.
The carbon filter (supplied separately) that
absorbs odors is installed behind the alumi-
nium grease filter (refer to Fig 16 - 17).
11