Duct Run Calculation; Electrical; Electrical Supply - Sirius SU900 Notice D'utilisation Et D'entretien

Duct Run Calculation.

The maximum duct run before effecting the
performance of the hood is 100'. Calculate
your duct run by measuring linear feet and
adding the elbows, transitions and caps ba-
sed on the table below.
Maximum Run
6" or 3 1/4 x 10" duct
Deduct
Each 90 elbow used
Each 45 elbow used
Each 6" or 3 1/4 x 10" duct
Transition used
Each 3'1/4 x 10" to 6"
Transition used
Side Wall with damper
Roof Cap
WARNING: All electrical work must be
performed by a qualified electrician.
Please ensure that the appropriate electrical
codes or prevailing local building codes and
ordinances are adhered to.
Ensure that the electricity supply is discon-
nected at source. Do not use an extension
cord or adapter plug with this appliance.
This appliance must be grounded. Connect
to a properly grounded branch circuit, pro-
tected by a 15 amp circuit breaker.
The ducting connection to the hood must be
in line with the central vertical axis of the
range hood 1" away from the back wall on
which the hood is to be mounted.
Range hoods may interrupt the proper flow
of combustion gases from fireplaces, gas
furnaces and gas water heaters.
To minimize the risk of drawing these lethal
100 FT
gases back into the home, please follow the
heating equipment manufacturers safety
standards and guidelines carefully.
15FT
Refer to NFPA and ASHRAE for additional
9FT
information.
1FT
5FT
30FT
30FT
E L E C T RIC A L

Electrical Supply.

This appliance requires 120V/60Hz, 3amp
electrical supply - ensure an appropriately
qualified person completes the electrical ho-
ok-up. The connection point for the electrical
supply is at the top of the unit, therefore the
electrical supply must be run down from the
ceiling alongside the ductwork.
All electrical and venting hook-ups must be in
place before commencing installation of the
hood-fan.
8