Adjusting The Cut Height; Switching On And Off; Working With The Lawnmower - Grizzly ERM 1333 G Traduction De La Notice D'utilisation Originale

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The lawn mower can be adjusted to the
following cutting heights by changing the
position of the wheels
20 mm - Short cutting height
40 mm - Medium cutting height
60 mm - Tall cutting height
1. Slide your hand under the
housing of the device (10) and
pull the spring-loaded wheel
axle (18) towards you.
2. You can now adjust the wheel
axle (18) while pulling it up or
down in order to reach one of
the three cutting heights.
3. Once the desired height positi-
on has been reached, allow the
wheel axle (18) to slide back
into the guide position.
The correct height is around 30 –
45 mm for a decorative lawn and
around 45 - 60
lawn.
A higher cut height should be
selected for the first cut of the sea-
son.

Switching On and Off

G
1. Plug the mains lead into the ex-
tension cable outlet (13) at the
curved handle (1).
2. Turn the end of the mains lead
into a loop and hook it into the
cable strain relief (15).
( 7):
mm for a used
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the
release button (14) on
the handle at the same
time as pressing the
start lever (16). Release the
release button (14).
4. To switch off, release the start
lever (16).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.

Working with the Lawnmower

Beachten Sie den Lärmschutz und
örtliche Vorschriften.
Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Start mowing near the socket and
work away from the socket.
• Always keep the extension cable
behind you and when you turn, move
it to the side that has already been
mowed.
• Run the equipment at a walking pace,
GB
61