Inserting / Removing Grassbox; Adjusting The Cut Height - Grizzly ERM 1500-33 LF Traduction De La Notice D'utilisation Originale

GB
Assembly
Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Mounting grip rod
Assembling the Curved Handle
1. Insert the lower handle (3) into
the slot in the air cushion deck
(8).
2. Attach the lower bar (3) with the
screws provided.
3. Fasten the bow-type handle
(1) with the enclosed screws,
washers and clamping levers
(2) to both right and left sides
of the lower bar (3). Two posi-
tions are possible. There are
two possible positions.
4. Turn the tightening lever (2) in
the clockwise direction.
5. 5. Lock the clamping lever (1)
by pressing it in the direction of
the bow-type handle (2)
tightening lever fit the bar so
that a tensioning with medium
force can be carried out. Other-
wise, the tightening levers must
be turned clockwise for tensio-
ning them or anti-clockwise to
loosen them
6. clip the cable holder (12) into
the bar (3) and thus fix the ca-
ble. (11).
64
All manuals and user guides at all-guides.com
‚
. The

.
Operation

Inserting / removing grassbox

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of
1. To fit the grassbox (6), lift the
impact protection (5) and insert
the grassbox. Fold the collision
guard (5) onto the grass box
(6). It holds the grass box in the
correct position.
2. To remove the grassbox (6), lift
the impact protection (5) and
remove the grassbox. Fold the
collision guard (5) back onto the
mower housing (10).

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The mower can be adjusted by the inser-
tion of spacers (
cutting heights:
10 mm - Short cutting height
18 mm - Medium cutting height
25 mm - Medium cutting height
33 mm - Tall cutting height
1. Tilt the machine over
2. Using non-slip gloves, hold the
blade (18) firmly. Loosen the
blade bolt (17) with the supplied
spanner (4).
3. Depending on the desired cut-
ting height, click the spacers
injury..
19) to the following