Installing The Grass Box; Operation; Mounting/Removing The Grass Box; Adjusting The Cut Height - Grizzly ARM 2433-20 Traduction De La Notice D'utilisation Originale

GB
When the tensioning levers (2a)
are loosened, the curved handle
can be folded down for storing the
equipment. Ensure that the power
A
cable ( 13) is not caught.

Installing the grass box

D
Pull the plastic straps over the
linkage tubes.
Attention: Do not operate the ap-
pliance until the collision guard
and grass box are fully installed.
Risk of injury!

Operation

The mower must only be set
when the motor is switched off
and the blades are shut-down.
There is a risk of personal injury.
Switch of the device, pull the ig-
nition key (12) and wait for the
blades to come to a stop.
Mounting/removing the grass
box
1. To mount the grass catch box (4)
E
lift the impact protection (5) and
mount the grass catcher box (4).
2. Lower the collision guard (5)
onto the grass box (4) - it will
keep it in place.
3. To remove the grass box (4),
lift the collision guard (5) and
unhook the grass box from the
mounting bracket. Flap down the
collision guard to the housing (9).
30

Adjusting the Cut Height

There are 5 different cutting heights:
65 mm - large cutting height
55 mm - medium cutting height
45 mm - medium cutting height
35 mm - low cutting height
25 mm - low cutting height
F
1. Hold the cutting height adjuster
(7) and move it to the correct
cutting height, as appropriate.
The correct height is around 25 – 45 mm
for a decorative lawn and around
45 –65 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Observe noise control and local
regulations.

Switching On and Off

G 1. Place the mower on a level sur-
face.
2. Lift the transparent cover (10)
on the device housing and insert
the charged battery (11) along
the guide rail into the device. It
locks into place audibly.
3. Insert the ignition key (12) in to
the opening provided.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
H
5. To switch on, press the release
button (15) on the handle at the
same time as pressing the start
lever (16). Release the release
button (15).