GB
rail into the device. It locks into place
audibly.
2. To remove the battery (7) from the de-
vice, press the release button (
on the battery and pull the battery out.
Operation
Caution! Risk of injury! Always
wear appropriate protective
equipment and work gloves
while working with the appli-
ance. Prior to each use, ensure
that the appliance is working
correctly. Ensure that the col-
lection bag is installed correctly
and the device has been mount-
ed properly. Do not use the
device if a switch is damaged.
Personal protective equipment
and a fully functional appliance
reduce the risk of injuries and
accidents.
Adjustments on the mower, as
well as assembly and disas-
sembly of the collection basket,
mulch kit and lateral ejection
chute, etc. may only be made
while the motor is switched off
and the blades are at a stand-
still.
Switch of the device, pull the con-
tact chip (
blades to come to a stop. There is
a risk of personal injury.
Observe noise control and local
regulations.
28
17) and wait for the
Mounting/removing the
grass box
7b)
1. To mount the grass catch box (13) lift
the impact protection (14) and mount
the grass catcher box (13).
2. Lower the collision guard (14) onto the
grass box (13) - it will keep it in place.
3. To remove the grass box (13), lift the
collision guard (14) and unhook the
grass box from the mounting bracket.
Flap down the collision guard to the
housing.
A level indicator is fitted on the
side of the grass bag.
Adjusting the Cut Height
There are 5 different cutting heights:
60 - 75 mm - large cutting height
40 - 60 mm - medium cutting height
25 - 40 mm - low cutting height
1. Hold the cutting height adjuster
(8) and move it to the correct
cutting height, as appropriate.
The correct height is around 25 – 45 mm
for a decorative lawn and around
45 –65 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Flap open:
grass catcher empty
Flap closed:
grass catcher full