Spypoint BF-8 Manuel D'utilisation page 5

8
DELAY
To select the time interval before the camera records another
photo or video.
Additional setting: it is possible to decrease the delay between
detections to 10 seconds (instead of 1 minute) by using the
following procedure. Note that the battery life will be
affected.
Turn OFF the camera. Press and hold the « UP » button, turn
the camera on. « 10_S » appears on the screen meaning the
1 minute delay has been replaced by a 10 second delay. To
reset the camera to 1 minute delay, follow the same procedure.
« 1_M » appears on the screen (see figure below).
Test light
MULTI-SHOT
To take up to 4 consecutive shots at each detection, with a 10
second delay between each photo. This option is available in
PHOTO mode.
VIDEO LENGTH
Allows you to select the recording duration when the camera is
set in VIDEO mode.
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet).
10_5
10 sec. delay 1 min. delay
9