Cutting Angle Adjustment - Promac 349V2 Manuel De L'utilisateur

ADJUSTMENTS
5. Positioning the work stop
Use the work stop supplied if you have to do several cuts on
pieces of the same length.
Loosen the lock handle A, place the work stop at the desired
distance from the blade.
Tighten the lock handle A again.
CAUTION! Make sure that the length stop does not
interfere with the downward movement of the blade.

6. Cutting angle adjustment

The band saw can cut at an angle varying from 0º
to 60º.
Loosen the lock handle B, turn the swivel support
until the mark on support matches desired angle
on the scale. Then lock the swivel support again
CAUTION! Make sure the lock handle B has
been tightened before turning on the machine.
7. Sliding blade guide
The sliding blade guide must be adjusted before
cutting a different workpiece. If the adjustment is
not done, it would result in an unclean cut.
Loosen the lock handle C, Slide the blade guide
to move it closer to the workpiece then retighten
the lock handle C.
8. Cutting speed
The cutting speed always depends on the material being
cut.
To select the most suitable speed, turn the control knob D
to increase or decrease the speed as you require.
Example:
Common steel:
Aluminum, alloy;
Pipes/sections:
40-60m/min
80m/min
70-80m/min
Swivel support
D
17
A
B
C C