Machine Care - Promac 349V2 Manuel De L'utilisateur

MAINTENANCE
Warning: Turn off the machine and disconnect from the power supply before conducting maintenance work
or settings.
Change the saw blade
Caution! Always wear protective gauntlets before changing saw blade.
 Remove the protective casing unscrewing the six screw
 Loosen the blade tension, turning the knob E in the anti-clockwise direction.
 Extract the blade first from the guides and then from the cast iron pulleys, check to make sure the blade
teeth are facing toward the work piece.
 Insert the new blade first between the guides and then into the cast iron pulleys.
 Turn the knob E, adjust the blade tension.
 Replace the protective casing.
 Reposition the blade guides in the correct position for next cut.

Machine care

 Usually check the condition of the power supply cords and replace them if they are broken, or even
worse if the internal wires are shown.
 Use a brush and a shop vacuum to remove chips and other debris from the machine.
 Always keep the machine handgrip clean to prevent accidental slipping during use.
 Remove the processing residues from the cutting area and the blade guides whenever necessary.
 If you do not intend to use the sawing machine for a long time, clean it and put it in a dry place if possible.
In these cases it is advisable to slacken off the blade so that it is not kept for any reason.
 To ensure effective machine operation, check the condition of the blade daily and sharpen it whenever
necessary.
19
E