Electrical Requirements; Power Supply And Motor Specifications; Grounding Instructions - Promac 349V2 Manuel De L'utilisateur

12. DISCONNECT TOOLS before servicing; when changing blade and other part.
13. USE RECOMMENDED ACCESSORIES. Consult the Operator's Manual for recommended accessories. The use of
improper accessories may cause serious injury.
14. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the cutting tool is unintentionally
contacted.
15. CHECK FOR DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its intended function – check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its
operation. A guard or other part that is damaged should be properly repaired or replaced.
16. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER "OFF". Don't leave tool until it comes to a complete
stop.
17. DON'T OVERREACH. Keep proper footing and balance at all times.
18. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest performance. Follow instructions for
lubricating and changing accessories.
19. DO NOT use power tools in the presence of flammable liquids or gases.
20. NEVER REMOVE GUARD, SAFETY DIVICES OR ART OF THE MACHINE.
21. BE CAREFUL. Pay attention to what you are doing. Work reasonably. Do not use the machine when you are tired.
22. HAVE YOUR MACHINE REPAIRED BY AN EXPERT ONLY! This machine meets the applicable safety provisions. Any
repairs may only be executed by an expert, using original spare parts; otherwise, the user could face a risk of injury.
23. Children and persons not familiarised with the machine and persons with limited physical, sensory and mental skills
must not use the machine.
SPECIFIC SAFETY INSTRUCTIONS FOR THE MACHINE
1. Secure the machine to a bench before operating.
2. The machine must be switched off before inserting material to be cut in the vice or before removing material to be cut
from the vice.
3. Keep your hands and fingers in a safe distance from the running saw blade at all times.
4. The saw blade must not be broken by hand.
5. Safety equipment and guards, etc, must not be removed.
6. Never remove the cutting chips by hand. Use a brush at all times.
7. Never leave the machine when in operation.

ELECTRICAL REQUIREMENTS

POWER SUPPLY AND MOTOR SPECIFICATIONS

WARNING:
To avoid electrical hazards, fire hazards, or damage to the tool, use proper circuit protection. Use a separate
electrical circuit for your tools. To avoid shock or fire, if power cord is worn or cut, or damaged in any way, have it replaced
immediately.

GROUNDING INSTRUCTIONS

WARNING:
This tool must be grounded while in use to protect the operator from electrical shock.
IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding provides a path of least resistance for electric current
and reduces the risk of electric shock. This tool is equipped with an electric cord that has an equipment-grounding
conductor and a grounding plug. The plug MUST be plugged into a matching receptacle that is properly installed and
grounded in accordance with ALL local codes and ordinances.
DO NOT MODIFY THE PLUG PROVIDED. If it will not fit the receptacle, have the proper receptacle installed by a qualified
14